Thrust ball bearing is a separable bearing, the shaft washer and seat washer can be separated from the cage and steel ball parts. The collar is a ferrule matched with the shaft, the seat ring is a ferrule matched with the bearing seat hole, and there is a gap between the shaft and the shaft. Imported thrust ball bearings have more structural modifications and are special bearings used to withstand axial forces. Thrust bearing is also called thrust bearing.

One-way thrust ball bearings consist of a washer ring with ball raceways and a cage loaded with balls. The ring installed on the shaft is called the shaft ring, the ring installed on the ring is called the seat ring, and the two-way bearing uses the intermediate ring installed on the shaft. One-way thrust ball bearings can bear axial load in one direction and can be used for axial positioning in one direction, but must not bear any radial load.

Types of one-way thrust ball bearings:
◆ Thrust ball bearing with flat race.

◆ Thrust ball bearing with self-aligning race.

These two types of bearings can be used together to compensate for angular misalignment between the bearing surface in the housing and the shaft.

Retainer:
◆ Stamped steel cage

◆ Nylon

◆ One-piece machined brass cage

◆ One-piece machined steel and copper cage

◆ Composite machined brass cage

Application:
Thrust ball bearings are only suitable for parts that are subjected to axial loads and have low rotational speeds.

◆ Hook.

◆ Vertical water pump.

◆ Vertical centrifuge.

◆ Jack.

◆ Low speed reducer.